FAQ: How To Repair Graco Paint Sprayer Xr9?

Why is my airless paint sprayer not spraying?

Pump inlet screen plugged or air in pump or hose. Remove and clean. Hold spray gun trigger in open position and run unit about 10 seconds until air is purged. Check for siphon tube leak.

Can you unclog a paint sprayer?

To revive a clogged nozzle, try this trick: First, pull off the nozzle and soak it overnight in a can of mineral spirits or paint thinner. Then, place the nozzle onto the end of a spray tube from a can of aerosol lubricant. Squirt a short blast of lubricant into the nozzle. Repeat, until the nozzle is cleared.

What would you do if your paint does not spray from your gun or comes out blotchy?

If your paint gun is not spraying paint at all, it’s most likely due to a clog either in the air vent hole or the hose. Clean any dried paint with a toothpick, and use a cleaning solvent to clear any remaining gunk. If you’ve cleaned your paint gun and find that it still isn’t spraying, take a look at the air supply.

What would cause a paint sprayer to not prime?

If the siphon hose has a hole in it or is not tightly secured to the airless sprayer the system may not be sealed and as a result, may suck air in while trying to pick up material. This can lead to the system not pressurizing well.

You might be interested:  Question: Which Is Best Paint Sprayer?

Why is my Graco sprayer not working?

Chances are the spray tip is clogged. Turn the spray tip 180 degrees to the unclog position. Then, aim the spray gun into a bucket and pull the trigger for one second to blast out the clog. Turn the spray tip back to the spray position and get back to the job.

Why is my Wagner paint sprayer not working?

When your Wagner paint sprayer won’t prime there are a few solutions to the problem. It is entirely possible that the priming or spraying valve is clogged with old material and gunk. If it’s not the prime or sprayer valve, it could be either the outlet or inlet valves. These can be unblocked by using the filter tab.

Why is my Graco paint sprayer leaking?

The spray gun is leaking from the Nozzle This occurs when the Needle Packing Nut is too tight, compressing the Needle Packing too tightly around the Needle. This occurs when the Needle Packing nut is too loose. Remember that the needle packing must be tight enough to prevent any leakage of paint material.

Leave a Reply

Your email address will not be published. Required fields are marked *