- 1 Why is my Graco sprayer not working?
- 2 Why is my airless paint sprayer not spraying?
- 3 Why is paint not coming out of my sprayer?
- 4 Why does my Graco paint sprayer spit?
- 5 Why is my Wagner paint sprayer not working?
- 6 Why does my airless paint sprayer leaving streaks?
- 7 Why is my paint sprayer making lines?
Why is my Graco sprayer not working?
Chances are the spray tip is clogged. Turn the spray tip 180 degrees to the unclog position. Then, aim the spray gun into a bucket and pull the trigger for one second to blast out the clog. Turn the spray tip back to the spray position and get back to the job.
Why is my airless paint sprayer not spraying?
Pump inlet screen plugged or air in pump or hose. Remove and clean. Hold spray gun trigger in open position and run unit about 10 seconds until air is purged. Check for siphon tube leak.
Why is paint not coming out of my sprayer?
If your paint gun is not spraying paint at all, it’s most likely due to a clog either in the air vent hole or the hose. Clean any dried paint with a toothpick, and use a cleaning solvent to clear any remaining gunk. If you’ve cleaned your paint gun and find that it still isn’t spraying, take a look at the air supply.
Why does my Graco paint sprayer spit?
Spray guns spit when air is being introduced into the fluid outside of at the air cap. A loose fluid nozzle does not properly seat in the tip of the spray gun and causes air to enter the fluid supply resulting in spitting.
Why is my Wagner paint sprayer not working?
When your Wagner paint sprayer won’t prime there are a few solutions to the problem. It is entirely possible that the priming or spraying valve is clogged with old material and gunk. If it’s not the prime or sprayer valve, it could be either the outlet or inlet valves. These can be unblocked by using the filter tab.
Why does my airless paint sprayer leaving streaks?
The main causes of streaks and disturbances in the spray pattern when using Airless devices are: Pressure set too low. Nozzle worn. Material supply disrupted (eg clogged filters)
Why is my paint sprayer making lines?
Answer: Streaks in the spray pattern, especially heavy bands at the outside edge, indicates low pressure at the tip. Using a tip that is larger than the maximum size or a tip that is worn larger will cause low pressure. The tip should also be the proper size for the type of material being sprayed.